Follow

    TESSALink Testbench - Zeroing a Transducer in ESI

    1. Ensure the ESI transducer is plugged into the computer via USB.

    2. Open the ESI software

    3. Once the sensor is detected, click “Zero Sensor” in the bottom left

    Zero_Sensor.png

    4. Verify it is the correct transducer, and click yes

    Accept_Warning.png

    5. Dismiss the success message

    Dismiss_Message.png

    6. Close the ESI software before opening test bench

    Was this article helpful?
    1 out of 1 found this helpful

    Comments